Trol-A-Matic Trolling Plate
In stock
Automatic Trolling Motor Plate by T&L Products of Michigan
This revolutionary trolling device allows you to operate your motor at a wide range of speeds from very slow to wide-open. Plus, it’s completely automatic and swings up as speed is increased, so there is absolutely no interference. Constructed of fiberglass-filled nylon, it will not rust or corrode. Works on most outboards or inboard out-drives from 50 hp on up. Mounts in just minutes. Not for use with Volvo out-drives.
Proven Performance
- Fully automatic
- No rust or corrosion
- Glass filled nylon construction
Speed Matters
- Fishermen know trolling speed is crucial
- Automatically swings up as speed is increased
- Works on most outboards and inboard drive 50 hp or higher (check size for compatibility on smaller outboards)
Easy to Install
- Mounts in minutes
- Simply drill four 1/4″ holes
- Stainless steel hardware included
Troll-A-Matic specifications:
- Bolt hole pattern (center to center): 5.063 in. on holes near the plate, 4.5 in. on the other
- Hole spacing (center to center), front to rear: 1.875 in
- Plate : 11.75 in. wide x 13.62 in. high from pivot pin
- Mounting hardware included (no instructions necessary)
- Mounts to bottom of cavitation plate
- Springs allow plate to hinge upward under full throttle
- Unit does not lock into a fully-horizontal position
- This item will not fit on Volvo outdrives because of the shape of the outdrives lower unit
- This trolling plate is not compatible with motors using a dual-propeller configuration
Reviews
4.9
-
Decent Product
0 people found this helpfulThis is my second one in 18 months. It does work very well in maintaining a slow speed but, for some reason I lost one of my springs and the bottom right corner broke off. I always try to minimize going into reverse and not go over 35 MPG to maintain its longevity. I'm not sure if the piece broke off because of the spring went missing or snapped. I also remove the unit when I know I will be pleasure boating as to not to wear out the springs. Maybe I'm wrong about removing the unit when not in use for its intended purpose but I'm just being cautious. -
115 Suzuki engine
0 people found this helpfulThis is my second also. Love them. Never have to worry about bending or pulling a cord . I have the first on another boat. Had it for about 8 years. Still working great. -
Great Product
0 people found this helpfulThis is my second trol-a-matic and it is an awesome product. I broke the first one, my mistake, but used it for about ten years. I have not installed the new one yet but I know it will work fine. I would recommend this product to anyone that trolls. -
Great Product
0 people found this helpfulThis is my second trol-a-matic and it is an awesome product. I broke the first one, my mistake, but used it for about ten years. I have not installed the new one yet but I know it will work fine. I would recommend this product to anyone that trolls. -
Easy install.
0 people found this helpfulThis was a replacement for a twenty year old plate that finally had enough. Install was easy as the bolt holes were already in the lower unit. The old plate was on three different motors and the installation was simple on all three. Beat of all, no cord to; mess with or forget.